This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
mantis:ide_simulator:firmware [2019/04/16 08:04] colin created |
mantis:ide_simulator:firmware [2021/04/02 04:56] colin Add new firmware release |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ==== Firmware upgrading ==== | + | ====== Firmware upgrading |
- | ====== Upgrade | + | ==== Upgrade ==== |
Upgrading the firmware on the device requires use of the command line interface. | Upgrading the firmware on the device requires use of the command line interface. | ||
Line 17: | Line 17: | ||
* The device should now be using the new firmware. | * The device should now be using the new firmware. | ||
- | ====== Flash functionality | + | ==== Flash functionality ==== |
The device supports two separate firmware banks, and whenever you upgrade, the previous version will still be available. You can inspect the contents of Flash using the following command: | The device supports two separate firmware banks, and whenever you upgrade, the previous version will still be available. You can inspect the contents of Flash using the following command: | ||
Line 28: | Line 28: | ||
</ | </ | ||
+ | ====== Available Firmware ====== | ||
+ | |||
+ | {{mantis: | ||
+ | |||
+ | * CLI upgraded to support cursor keys, including command history | ||
+ | * Experimental "Ultra High Density Floppy"/ | ||
+ | * Reworked audio playback, including improved volume support | ||
+ | * Automatic firmware installation (sadly, you must install this update manually to get it) | ||
+ | * Autorun files | ||
+ | * autorun.txt - command line commands to run at boot | ||
+ | * Various bugfixes and improvements | ||
+ | * Device 0 or 1 mode | ||
+ | * ' |