This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
mantis:ide_simulator:known_issues [2019/04/16 08:42] colin |
mantis:ide_simulator:known_issues [2021/06/29 21:38] colin |
||
---|---|---|---|
Line 3: | Line 3: | ||
Here's a list of known issues with the current version of the simulator. | Here's a list of known issues with the current version of the simulator. | ||
- | * **SD card slot is a little finnicky**\\ If possible, use USB0. Performance testing has indicated that a USB drive in USB0 has performance exceeding that of the SD slot anyway, so this is the preferred storage port. | + | * **SD card slot is a little finnicky**\\ If possible, use USB0. Performance testing has indicated that a USB drive in USB0 has performance exceeding that of the SD slot anyway, so this is the preferred storage port. If you have a Rev B2 board this has been corrected with a much easier to use slot. |
* **Device is much lower power than an optical drive**\\ Certain power supplies may expect a larger load on 5V or 12V lines, and so fail to start up correctly. In this case, you may need to install a load resistor over one or both of the power lines in your machine. Please ensure to use a resistor with a sufficiently large power capacity. | * **Device is much lower power than an optical drive**\\ Certain power supplies may expect a larger load on 5V or 12V lines, and so fail to start up correctly. In this case, you may need to install a load resistor over one or both of the power lines in your machine. Please ensure to use a resistor with a sufficiently large power capacity. | ||
+ |