User Tools

  • Logged in as: anonymous (anonymous)
  • Log Out

Site Tools


mantis:ide_simulator:known_issues

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mantis:ide_simulator:known_issues [2019/04/16 08:42]
colin
mantis:ide_simulator:known_issues [2019/04/25 17:01] (current)
colin
Line 5: Line 5:
   * **SD card slot is a little finnicky**\\ If possible, use USB0. Performance testing has indicated that a USB drive in USB0 has performance exceeding that of the SD slot anyway, so this is the preferred storage port.   * **SD card slot is a little finnicky**\\ If possible, use USB0. Performance testing has indicated that a USB drive in USB0 has performance exceeding that of the SD slot anyway, so this is the preferred storage port.
   * **Device is much lower power than an optical drive**\\ Certain power supplies may expect a larger load on 5V or 12V lines, and so fail to start up correctly. In this case, you may need to install a load resistor over one or both of the power lines in your machine. Please ensure to use a resistor with a sufficiently large power capacity.   * **Device is much lower power than an optical drive**\\ Certain power supplies may expect a larger load on 5V or 12V lines, and so fail to start up correctly. In this case, you may need to install a load resistor over one or both of the power lines in your machine. Please ensure to use a resistor with a sufficiently large power capacity.
 +  * **The device doesn'​t currently support multiple IDE devices**\\ Shouldn'​t be a problem for arcade games, but may be an issue if you're wanting to plug it into a PC. Hopefully this can be addressed in a future firmware update. As it is it will always simulate a "​master"​ device.
mantis/ide_simulator/known_issues.txt ยท Last modified: 2019/04/25 17:01 by colin